Home > Equipment > Boiling Equipment > Brew Kettles & Pots >

Kettle Dimpling Tool Kit


Alternative Views:

Our Price $23.99
Brand: Hop Goblin

Product Code: BE61031

Kettle Dimpling Tool is used to mechanically pull a flared die partly through your 7/8" drilled opening. Then once the flare is established you pull your fitting of choice (often a 1/2" FPT fitting) into place for soldering. Used on either your brew pot, kettle or keggle of choice.

Kit includes:
  • (1) 5/8" Bolt and Nut
  • (2) Pull Washers
  • (1) Seated Washer (for sitting inside 1" Die and centering)
  • (1) Stainless Steel Coupling
  • (1) Stainless Steel Flared Coupling
Brewers Note: Video explains the process very well. You do not pull the flared die completely through. You want to get the flare about 4/5 established and then use your 1/2" FPT fitting to complete the rest for a nice tight fit when soldering. This will also help hold the 1/2" FPT fitting tightly in place while you solder it.1/2" Female Stainless Steel Couplings are not included with this tool kit.

Bin: Blue Uniform-1

How to use a Dimpling Tool
2 Man Demo for Keggle Dimpling Tool
Part 2 - Dimpling Tool Demo

1/2" Female Stainless Steel Coupling 2" Stainless Fender Washers - 4 pack Keggle Stainless Steel Soldering Kit
Our Price $3.99

Our Price $2.79

Our Price $15.99

1/2-inch-female-stainless-steel-coupling 2-inch-stainless-fender-washers-4-pack keggle-stainless-steel-soldering-kit

Average Rating: 4.5 of 5 Total Reviews: 3 Write a review »

  0 of 0 people found the following review helpful:
February 19, 2018
Reviewer: Anne from Erin, NY United States  
Fast delivery.  Product as stated.  Great company!

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Dimpling Tool June 20, 2017
Reviewer: Timothy Spradlin from Piedmont, OK United States  
Works perfect.

Was this review helpful to you?

  0 of 0 people found the following review helpful:
Well built product. June 4, 2017
Reviewer: James from Murrieta, CA United States  
The product works good but you need to be careful how far you pull the dimple tool through. The video and the instructions say to pull it 4/5 the way through. In my experience, I only pulled it to where it just started to flair out. If you go to far you can just tao the kettle back in place but it will be a tighter seal if you flair less out. I would buy this again but I don't think it will ever break.

Was this review helpful to you?